EDGE-1830 EDGE-2440 / EDGE-3240 / EDGE-2460 / EDGE-3260 / EDGE-3860 / EDGE-4460 / EDGE-3270
Original Service Manual 10 Rev 1.6, January 2021
3. Tools Required for Service
These are the basic tools requirements to handle most of the repairs in this manual.
❖ Instruments
> Water Manometer. Best choice: Dwyer Series 1213-15
> Digital Multimeter(s). Choices vary: (low; mid; high) Craftsman 82008;
Amprobe AM-570, Fluke 87-5
- V (AC and DC)
- A, mA, μA (AC and DC)
- Ohm / Ω
- CAP / /
❖ Tools
> #2 Phillips screwdrivers, 1.5” and 4” shaft
> Right angle, offset Phillips screwdriver
> 1/8” Standard screwdriver
> 2x Needle nose pliers
> Wire snips, strippers, crimpers
> Socket Set: 1/4”, 5/16”, 3/8”, 7/16”, 1/2”, 9/16”, and 12” of extension
> Wrench Set: 1/4”, 5/16”, 3/8”, 7/16”, 1/2”, 9/16”, 11/16”
> 2x 12” Pipe wrenches
> 1x 12” Adjustable wrench
> SAE Allen wrench set
> Heavy duty rivet gun for structural repairs. Best economical choice: Pittsburgh 66422
> Dead Blow hammer
> Wheel Puller for fan blade removal
❖ Supplies
> TFE Pipe sealant
> 220/320 sandpaper or emery cloth
> Leak detector solution (soap water solution)
To Next Page
Loading...
Need help?
General
