EdgeStar KC2000 User Manual

Closed CO
2
valve and/or
shut-off valve.
Ensure that both the CO
2
cylinder and regulator
shut-off valve are open.
Empty beer keg. Replace beer keg.
Line or dispenser
obstructions.
Verify that there are no
‘kinks’ or obstructions in
either the air line or
dispenser line and that
neither are frozen.
Improper connections(s) Ensure all connections are
secure and all seals are in
place and in good
condition.
Sputtering Draw Dispense system requires
cleaning.
See “Cleaning and
Maintenance”
Keg Coupler installed
incorrectly
Check seal between keg &
faucet
Line or dispenser
obstructions.
Verify that there are no
obstructions in either the
air line or dispenser line
and that neither are frozen.
Improper draw technique See “Using Proper Draw
Technique”
Faucet Dripping Handle not fully returned to
close position.
After every pour, ensure
the handle is returned to
the off position.
Faucet requires cleaning See “Cleaning and
Maintenance”
Rapid CO
2
cylinder
discharge
Improper connection, air
line leak
Ensure proper connection
of air line at CO
2
regulator,
and/or check air line for
possible leaks
Difficulty Manipulating
Faucet handle
Faucet requires cleaning See “Cleaning and
Maintenance”
Damaged handle stem Remove handle and
connector nuts and inspect
stem for possible damage.
Abnormal beer taste and/or
smell
Dispense system requires
cleaning.
See “Cleaning and
Maintenance”
Contaminated dispense
system.
Check hoses for possible
air leaks.
The beer exceeded self-life. Replace Beer Keg
15

EdgeStar KC2000 Specifications

General

Brand	EdgeStar
Model	KC2000
Category	Kitchen Appliances
Language	English