5
Note: You must adjust the feet to level the wine cooler.
Caution: Do not over-tighten the screws as this may cause damage to the handle or to the
stainless steel door.
Leveling the Wine Cooler
It is important for the wine cooler to be leveled in order to work properly. It can be raised or
lowered by rotating the plastic sheaths around each of the feet on the bottom of the machine. If
you find that the surface is not level, rotate the feet until the wine cooler becomes level .You may
need to make several adjustments to level it. We recommend using a carpenter’s level to check
the machine.
1. Place a carpenter’s level on top of the product to see if the wine cooler is level from front-to-
back and side-to-side.
2. Adjust the height of the feet as follows:
Turn the leveling feet to the right to lower that side of the refrigerator.
Turn the leveling feet to the left to raise that side of the refrigerator.
Installing the Door Handle
To install the door handle:
1. Open the door and carefully pull the door gasket around the area where the handle is to be
installed.
2. Insert each Phillips head screw through the gasket side of the door until the screws pass
through the door.
3. Align the handle with the screws and tighten the screws using a Phillips head screwdriver
until the handle is flush against the door frame.
4. Carefully press the door gasket into its original position.
To Next Page
Loading...
