4
Plug into a grounded 3-prong outlet.
Never remove the grounding prong from the plug.
Never use an adapter to bypass the grounding prong.
DO NOT use an extension cord.
Failure to follow these instructions can result in fire, electrical shock, or death.
Tip: Use a surge protector to protect your wine cooler from electrical surges.
Installation Clearance Requirements
To ensure proper ventilation, allow at least 10” of clearance at the back, 5” at the top, and
5” at the sides.
The wine cooler should be installed on a firm and level surface that will be able to support
the entire weight of a fully loaded unit. It is important for the wine cooler to be level in order
to work properly. If needed, you can adjust the height of the wine refrigerator by rotating the
feet. See the “Leveling the Wine Cooler” section on page 5.
A standard electrical supply (115 V only, 60 Hz), properly grounded in accordance with
National Electrical Code and local codes and ordinances is required.
Electrical Requirements
Before you move your wine cooler into its final location, it is important to make sure you have the
proper electrical connection:
A standard electrical supply (115 V, 60Hz), properly grounded in accordance with the National
Electrical Code and local codes and ordinances, is required.
The fuse (or circuit breaker) size should be 15 Amps.
Recommended Grounding Method
For your personal safety, this appliance must be grounded. It is equipped with a power
supply cord that has a 3-prong grounding plug. To minimize possible shock hazard, the cord
must be plugged into a mating 3-pronged wall socket, and grounded in accordance with the
National Electrical Code and local codes and ordinances. If a mating wall socket is not
available, it is the personal responsibility of the customer to have a properly grounded, 3-
prong wall receptacle installed by a qualified electrician.
Important Notes:
• Choose a location that has
ambient temperatures above
50°F and below 95°F.
Operation outside these
temperatures may result in
lowered efficiency or cause
other adverse effects.
• This unit MUST be installed
in an area protected from the
elements, e.g., wind, rain,
water spray or drips.
• The wine refrigerator should
not be located next to ovens,
grills or other high heat
sources.
• Do not kink or pinch the
power supply cord between
the wine refrigerator and wall
or cabinet.
To Next Page
Loading...
