3
Important: Do not remove any safety, warning, or product information labels from your wine
cooler.
Important Notes:
Choose a location that has ambient temperatures of 78° F. Operation outside this temperature may
result in lowered efficiency or cause other adverse effects.
This unit MUST be installed in an area protected from the elements, e.g., wind, rain, water spray or
drips.
The wine cooler should not be located next to ovens, grills, or other high heat sources.
Installing the Wine Cooler
The wine cooler should be installed in accordance with local electrical code requirements. The
wine cooler should also be placed in a location that is strong enough to support its total weight,
keeping in mind that it will weigh substantially more when fully loaded than when empty.
Before you plug the wine cooler into a power supply, be sure to let it stand upright for at least 24
hours to allow the temperature to acclimate.
Unpacking the Wine Cooler
Carefully remove the packaging materials. Remove any shipping tape and glue from your wine
cooler before using. Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive
cleaners to remove tape or glue. These products can damage the surface of your wine cooler.
Type of Installation
This wine cooler has been designed for free-standing installation only. There must be adequate
ventilation space around the top, back, and sides of the unit.
Free-standing Installation:
A free-standing installation will allow you to install the wine cooler in almost any place you
desire. You must follow the stated instructions for electrical requirements, installation
clearance, and leveling the wine cooler.
Tip: Gather the model
and serial number
from the product label
and write them down
before installing the
wine refrigerator.
Warning: DO NOT install the wine cooler built-in or behind a closed cabinet door.
To Next Page
Loading...
