Edgetech 4125 SIDE SCAN - Disassembly; Figure 5-1: Tow Vehicle Parts of Note; Figure 5-2: Electronics Bottle and Transducer Array Sections Separated

5-2
4125 SIDE SCAN SONAR SYSTEM 0004823_REV_C
5
5.2.1
Disassembly
To disassemble the tow vehicle:
1. Place the tow vehicle on a clean, dry, flat
surface.
2. Remove the eight screws that secure the
electronics bottle section to the transducer
array section of the tow vehicle.
3. Pull the two sections apart far enough to be
able to access the connectors inside.
Transducer
array section
Screw (8)
Electronics
bottle
section
Figure 5-1: Tow Vehicle Parts of Note
Figure 5-2: Electronics Bottle and Transducer Array
Sections Separated