5-4
4125 SIDE SCAN SONAR SYSTEM 0004823_REV_C
8. If it is desired to reconnect the tow cable
connector for troubleshooting and test
purposes, place the electronics chassis
alongside the transducer array of the tow
vehicle and reconnect the connectors.
WARNING!
With the tow vehicle powered, high voltages that can cause injury or
death are present on the electronics chassis. Use caution when working
on the electronics chassis with the tow vehicle powered.
5
Before reassembling the tow vehicle, replace O-Rings with new ones from the accessories kit.
When installing a new O-ring, first clean the O-ring surfaces on both the housing and the end cap with a
paper towel, and then apply a light coating of silicone lubricant to the new O-ring around its entire surface
before installing it. If no scratches, nicks, or dirt are found when cleaning the O-ring, leave it installed and
apply a light coat of silicone grease only.
To reassemble the tow vehicle, reverse the disassembly procedure.
Electronics
bottle connector
end cap
Figure 5-5: Removing the Electronics Chassis from the
Electronics Bottle
To Next Page
Loading...
