To Next PageTo Next PageHow to fix a EdilKamin Stove with a display-control panel off?
If the display and control panel on your EdilKamin Stove are off, the issue is likely due to a lack of mains voltage. First, ensure that the power cord is properly connected. If it is, check the house fuse to see if it has blown.
Why EdilKamin Iris Plus ignition failure?
If your EdilKamin Stove fails to ignite, it might be due to a build-up of unburnt material in the combustion chamber. To resolve this, clean the combustion chamber.
What to do if EdilKamin Iris Plus Stove remote control not working?
If your EdilKamin Stove's remote control isn't working, it could be due to a couple of reasons. First, you might be too far from the pellet fire, so try moving closer. Alternatively, the remote control battery may be flat; check the battery and replace it if necessary.
Why no flame appears in EdilKamin Iris Plus Stove?
If no flame appears in your EdilKamin Stove (remembering that it only appears 5 minutes after pressing the 0/1 key), the auger may not have been filled. Fill the auger, referring to the ignition instructions for guidance.
How to fix EdilKamin Stove outlet air not hot?
If the outlet air from your EdilKamin Stove isn't hot, the heat exchanger may have too much soot. Clean the heat exchanger from inside the firebox to resolve this issue.
General| Type | Pellet Stove |
|---|---|
| Heating power (max) | 8 kW |
| Tank capacity | 15 kg |
| Heatable volume | 200 m³ |
| Flue Gas Outlet Diameter | 80 mm |
| Material | Steel |
| Glass Door | Yes |
| Secondary Combustion | Yes |
| Warranty | 2 years |
| Burn time (min) | 8 hours |
| Fuel Type | Wood |
Crucial safety guidelines for operation and installation, including warnings and precautions.
Details on recommended pellet types, their characteristics, and potential issues with unsuitable fuels.
Guidelines for optimal placement, clearances, and physical setup of the appliance within the room.
Explanation of the pellet fire's negative pressure venting, pipe sizing, and sealing requirements.
Requirements for safe termination of the exhaust vent into an open space, avoiding enclosed areas.
Addresses common operational problems like display errors, lack of heat, and ignition failures.
Explains specific shutdown error codes (H1-H7) and their potential causes related to air flow or temperature.
