PAGE11
Weekly Timer Program built into the Iris Plus Control Panel
Weekly time programmer built into panel
Using the weekly time programmer built into the central panel
it is possible to set 3 ignition programmes:
It is possible to enable one or more of the three settings on
When on standby, the display alternates between showing the
ignition mode (P1, P2, P3 or a temperature) and the clock.
Refer to page 10 for each of the buttons to press.
Setting the clock
appears then release, tS appears.
3. Press the “-” key until SEt appears.
changed with the “-” key, which decreases the time by
one minute each time it is pressed, and with the “+” key,
which increases it by 15 minutes each time it is pressed.
with the “-” and “+” keys.
Enabling programmes
appears then release, tS appears.
3. Press the “+” key until ProF appears.
If so you can exit thie section by pressing O/1 and proceed to setting
program section.
5. Press the “+ “ or “–” key until PrOn appears.
8. The pellet fire is now in PrOn mode and will accept timed
on and off commands.
Setting a program (e.g. Pr01)
appears then release, tS appears.
3. Press the “+” key twice until Pr 1 appears.
“on time”. It may be changed with the “+” and “–” keys in
ten-minute intervals.
with the off time. This may be changed with the “+” and
“-” keys in ten-minute intervals.
program 1 is not enabled on day 1, Monday). This may be
changed into Ond1 (which means program 1 is enabled
on day 1, Monday) using the “+” and “-” keys.
the desired day or days are selected then toggle on or off
fire to turn on at 4pm and off at 6pm Monday to Friday
with Program 1 then turning on at 8am and off at 10am
Saturday and Sunday with program 2.
On and off times may be set for Pr 2 and Pr 3 in a similar way,
and it can be decided which days they are enabled on.
speed up for 10 seconds to blow excess ash from the burn pot.
To Next Page
Loading...
Need help?
General