PAGE13
Weekly Timer Program built into the Little Control Panel
Weekly time programmer built into panel
Using the weekly time programmer built into the central panel
it is possible to set 3 ignition programmes:
One or more of the three programs can be enabled for
When on standby the display alternates between displaying
the ignition mode (P1, P2 or P3 or a temperature) and the
current time.
Refer to page 12 for each of the buttons to be pressed.
Setting the clock
appears then release, tS appears.
2. Press (-) and “Prog” will appear.
3. Press “Menu” and “ProF” will appear. Press the (-) key
and “SEt” will be displayed.
4. Confirm with the “Menu” key, which will display
and (+) keys.
5. Once the hour has been set, confirm with “Menu” and the
keys.
6. Confirm with “Menu” and “Prog” will appear.
Enabling programmes
appears then release, tS appears.
2. Press (-) and “Prog” will appear.
3. Press “Menu” and “ProF” will appear.
If so you can exit thie section by pressing O/1 and proceed to setting
program section.
4. Confirm by pressing the “Menu” key, pass now to “on”
with the (-) or (+) keys.
5. Confirm with the “Menu” key and “Prog” will appear.
6. The pellet fire is now in “PrOn” mode and will accept
timed on and off commands.
Setting a program (e.g. Pr01)
appears then release, tS appears.
2. Press (-) and “Prog” will appear.
3. Press “Menu” and “ProF” or “PrOn” will appear. Press (+)
until “Pr 1” appears (after PrOn has been set previously).
4. Confirm with the “Menu” key and OnP1 will appear and
then the desired set hour for programme 1 ignition.
5. The time can be changed using the On/off (-) or (+) keys.
for day1, continue to go through the days, disabling/
8. Press (+) to enable it, after which Ond1 appears,
indicating that program 1 is enabled for Monday.
10. Press the “On/off” to exit.
11. Pr02 and Pr03 on and off times and the days on which
they are enabled can be set in a similar way.
12. A small green bar will light-up in the bottom right corner of
the control panel when a program is enabled for that day.
speed up for 10 seconds to blow excess ash from the burn pot.
To Next Page
Loading...
Need help?
General