EdilKamin MYA User Manual

- 34 -
ENGLISH
INSTRUCTIONS FOR USE
)LOOLQJWKHFRFKOHD
7he ¿rst time you use the product, or should the tank be completely emptied of pellets, to ¿ll the coclea press both keys “”
and “±” on the remote control at the same time, holding for a few seconds. As you release the keys, the display should show the
wording “LOAD”. 7his should be carried out before ignition if the stove has stopped due to having run out of pellets, at the end of
operation to empty the combustion pot before turning.
It is quite normal for some pellets to remain, that the cochlea cannot suction.
$XWRPDWLFLJQLWLQJ
With the stove on stand-by, press and hold the key
, on the remote control for 2 seconds. 7his will start-up the
ignition procedure, showing the wording “S7AR7”. At the same time, a countdown in seconds begins (from 1020 to 0).
Ignition is not at a preset time, however: its duration is automatically shortened if the board reports that certain tests have
been passed. 7he Àame appears after about 5 minutes.
0DQXDOLJQLWLQJ
7emperatures of below & will not allow the electrical resistance to heat suf¿ciently. In this case, or should the
resistance be temporarily out of action, Diavolina® type ¿re-starters can be used.
Insert a piece of lit Diavolina into the combustion chamber, close the door and press
the remote control.
32:(55(*8/$7,21
5HPRWHFRQWUROPDQXDORSHUDWLRQ
With the stove working, press the key “M” on the remote control once. 7he display will show the word “3OWER 3”.
(specifying the power at which the insert is working). 3ress the keys “” or “±” to increase or decrease the insert¶s
working power (from “3OWER 31” to “3OWER 35”).
5HPRWHFRQWURODXWRPDWLFRSHUDWLRQ
3ress key “A” to switch to automatic operation, adjusting the temperature desired for the room (use the “” and “±” keys
to set the temperature from 5& to 5&, and the stove will regulate working power required to reach the temperature set.
If a temperature below that of the room is set, the insert will stay on “3OWER 31”.
7XUQLQJRII
With the stove running, press and hold the key
rom the remote control for 2 seconds. 7he turn-off procedure will begin,
showing a countdown on the display from 9 to 0 (for a total of 10 minutes).
7he turn-off phase involves:
 Interruption of pellet supply
 Ma[imum ventilation.
 Smoke e[pulsion motor.
1HYHUSXOOWKHSOXJRXWZKLOVWWKHGHYLFHLVVWLOOLQWKHSURFHVVRIWXUQLQJRII
OPERATIONS THAT CAN ONLY BE CARRIED OUT BY REMOTE CONTROL
&ORFNUHJXODWLRQ
3ress and hold the key “M” for 2 seconds to access the “&lock” menu. 7his allows you to set the internal electronic board
clock. By then pressing the key “M”, the following data appears in sequence and can be regulated:
day, month, year, hour, minutes, day of the week.
7he wording “SA9E""” will appear for con¿rmation with “M”. 7his will allow you to check that the operations performed are
correct, prior to completion (the wording “SA9E” will then be shown on the display).

EdilKamin MYA Specifications

General

Brand	EdilKamin
Model	MYA
Category	Pellet stove
Language	English