USER INSTRUCTIONS
- Relax function
Natural convection function with automatic power
limiting.
This function is available in all modes: automatic,
manual and crono.
Hold down the “M” button to activate the Relax function:
Hold it down again to deactivate it.
The stove reduces its power output and after a few
minutes switches the fan off too.
Pressing OK in this mode has no effect.
The “+” and “-” buttons allow you to increase/decrease
the room setpoint (in automatic mode only)
Menu
Press the “M” button to display the menu.
When the menu displays, the buttons have the
following functions:
“+”: scroll up
“-”: scroll down
press and release “OK”: enter menu option
press and release “M”: quit menu option
Press the ON/OFF button to confirm and return to the
main page.
- Stand by
When the Stand by function is active, in automatic and
timer modes, the stove shuts off when the temperature
setpoint is reached and turns on again when the
temperature drops.
When the Stand By function is not active, the stove
sets itself to minimum power when the temperature
setpoint is reached
Press “OK” to enter the function from the Menu.
Use the “+/-” buttons to select OFF or ON.
Press “M” to quit without saving.
Press “OK” to confirm and return to the previous menu
level.
If you selected ON, the display shows the minutes
for which the stove will continue running at minimum
power even when the temperature setpoint has been
reached.
Press the ON/OFF button to confirm and return to the
main page.
The stove is programmed by default with a
delta of +/- 1 °C to optimise comfort.
The technician can change this setting
during commissioning to suit the needs of
the application.
The display shows the temperature
rounded down, so that both 20.1°C and
20.9°C display as “20°”
To Next Page
Loading...
Need help?
General
