IRC-3 panel with CM1N
Location:
Installed By:
For Service, Contact:
Inspected By:
Per NFPA Standard:
(check all that apply)
NFPA 72, Ch.
NFPA 70, NEC Article 760
Date:
Power Supply:
Primary:
Secondary:
Location:
Type:
Fuses:
Specs:
1 3
4 5
6 7
OPERATING INSTRUCTIONS
NORMAL Condition:
Normal (green) LED flashes; time indicated at display.
AP: = Active Points - the number of off-normal points.
MW: = Messages Waiting - the number of unacknowledged messages.
To ACKNOWLEDGE................. Press "NEXT/ACK" switch.
Press "RESET" switch. (ONLY after investigation of Alarm condition.)
Press "ALARM SILENCE" switch. Any new alarm received by the system
will resound devices.
Press "DRILL/ALL CALL" switch.
For additional information, refer to manual P/N 270180.
These instructions to be framed and mounted adjacent to control panel.
Press "NEXT/ACK" switch to acknowledge all messages waiting, then
press "TROUBLE SILENCE" switch.
Press "NEXT/ACK" switch to acknowledge all messages
waiting, then press "TROUBLE SILENCE" switch.
To SILENCE Buzzer..................
To SILENCE Buzzer......................................
To SILENCE Audible Devices..
To DRILL (sound) All Audible Devices.......
To RESET System.....................
Display indicates the following:
Display indicates the following:
DP: = Disabled Points - the number of disabled points.
ALARM Condition:
Alarm (red) LED is ON; buzzer pulsates; Normal (green) LED is OFF.
TROUBLE Condition:
Trouble (amber) LED is ON; buzzer pulsates; Normal (green) LED is OFF.
To Previous Page
Loading...
