1
INTRODUCTION
1.1
Scope of this manual
This manual provides installation, operation and maintenance instructions for the Water Cooled
Crystal Holder, Crystals and Oscillator Unil You must use the Water Cooled Crystal Holder,
Crystals and Oscillator Unit as specified in this manual.
Read this manual before you install and operate the Water Cooled Crystal Holder, Crystals and
Oscillator Unit. Important safety information is highlighted as WARNING and CAUTION
instructions; you must obey these instructions. The use of WARNINGS and CAUTIONS is
defined below.
The units used throughout this manual conform to the SI international system of units of
measurement.
Definition of terms
1.2
Figure 1 defines the process terms used in this instruction manual.
1.
2.
3.
4.
5.
6.
7.
Substrate
Crystal head
Crystal
Deposition {deposition rate)
Deposition source
Evaporation {evaporation rate)
Deposited layer
<
,
...
0;
0
,
a
<
Figure 1 -Definition of process terms
Water Cooled Crystal Holder
1
To Next Page
Loading...
Need help?
General
