To Next PageTo Next Page
Need help?Do you have a question about the Edwards ES Series and is the answer not in the manual?
General| Category | Medical Equipment |
|---|---|
| Manufacturer | Edwards Lifesciences |
| Type | Hemodynamic Monitoring System |
| Series | ES |
| Compatibility | Compatible with a range of Edwards Lifesciences sensors and monitoring platforms |
Defines the scope of the manual and key terms used for ES/EH combination systems.
Attaches base runners to the ES pump feet using specified bolts and torque.
Fits the O-ring and adapter to the EH pump exhaust using bolts and clamps.
Secures the EH pump to the ES pump using the provided O-ring and bolts.
Performs a leak test on the assembled system to ensure no hazardous substance leakage.
Places base runners on the work bench and sets hole centres at 376 mm for frame mounting.
Screws grub screws into the feet of the pump for alignment with base runners.
Lines up grub screws with base runner holes and lowers the pump onto the runners.
Assembles the main frame by connecting end frames, cross braces, and support channels.
Attaches slings to the assembly and lifts it from the bench to the floor.
Removes protective cover and clamps bellows and spacer to the EH pump outlet.
Lowers the EH booster to the frame and bolts it into position.
Tests the system for leaks after assembly to prevent hazardous substance or air leakage.
