Edwards ES Series

© Edwards Limited 2014. All rights reserved. Page i
Edwards and the Edwards logo are trademarks of Edwards Limited.
Contents
A352-02-840 Issue A
Contents
Section Page
1 Introduction ....................................................................................... 1
1.1 Scope and definitions ................................................................................................... 1
2 Safety ............................................................................................... 1
3 Unpack and Inspect ............................................................................... 1
4 EH - ES direct mount assembly procedure .................................................... 6
4.1 Base runner mounting to pump ........................................................................................ 6
4.2 Adapter mounting to booster .......................................................................................... 7
4.3 Mount the EH to the ES pump .......................................................................................... 8
4.4 Leak test the system .................................................................................................... 9
5 EH - ES frame mount assembly procedure .................................................. 10
5.1 Base runner preparation ...............................................................................................11
5.2 Grub screw alignment and installation ..............................................................................12
5.3 Base runner alignment .................................................................................................13
5.4 Main frame assembly ...................................................................................................14
5.5 Move assembly ..........................................................................................................16
5.6 Bellows installation .....................................................................................................17
5.7 Booster installation .....................................................................................................19
5.8 Leak test the system ...................................................................................................20
For return of equipment, complete the HS Forms at the end of this manual.
cg/04/14