D395-90-880 Issue E
Page ii © Edwards Limited 2010. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.
Contents
5.4 Software upgrade .......................................................................................................18
5.5 Calibration service ......................................................................................................18
6 STORAGE AND DISPOSAL ....................................................................... 19
6.1 Storage ...................................................................................................................19
6.2 Disposal ...................................................................................................................19
7 SPARES AND ACCESSORIES ..................................................................... 21
7.1 Introduction .............................................................................................................21
7.2 Accessories ...............................................................................................................21
Appendix A Error Numbers ............................................................................ 23
Appendix B RS232 Commands ........................................................................ 25
Appendix C RS232 Queries ............................................................................ 27
Index .............................................................................................. 29
For return of equipment, complete the HS Forms at the end of this manual.
Illustrations
Figure Page
1 Pin connections for an 8-way FCC/RJ45 ............................................................................. 4
2 Pin connections and pin-out for the analogue / relay connector ................................................ 5
3 Pin connections for the serial comms connector ................................................................... 6
4 Bench mounted dimensions (mm) ..................................................................................... 7
5 Panel cut-out required .................................................................................................. 8
6 Panel mounting the ADC ................................................................................................ 8
7 Rear panel connections ................................................................................................. 9
8 IBM PC RS232 interface - 9-way ......................................................................................10
9 IBM PC RS232 interface - 25-way .....................................................................................10
10 Front panel displays ....................................................................................................11
To Next Page
Loading...
