© Edwards Limited 2007. All rights reserved. Page 13
Edwards and the Edwards logo are trademarks of Edwards Limited.
Installation
A371-32-880 Issue C
z if you operate the pump with an inlet pressure greater than 10 mbar for extended periods or
z if you frequently pump down from atmospheric pressure.
z The mist filter will trap the oil exhausted from the pump: you can re-use the oil if it is not contaminated.
3.9 Leak-test the system
Leak-test the system and seal any leaks found after you have installed the pump, to prevent leakage of substances
out of the system and leakage of air into the system.
To Next Page
Loading...
