A371-32-880 Issue C
Page ii © Edwards Limited 2007. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.
Contents
5.9 Fit new blades ...........................................................................................................22
5.10 Test the motor condition ..............................................................................................22
5.11 Fault finding .............................................................................................................23
6 Storage and disposal ........................................................................... 25
6.1 Storage ...................................................................................................................25
6.2 Disposal ...................................................................................................................25
7 Service, spares and accessories .............................................................. 27
7.1 Introduction .............................................................................................................27
7.2 Service ....................................................................................................................27
7.3 Spares .....................................................................................................................27
7.4 Accessories ...............................................................................................................27
7.4.1 Inlet catchpot * ......................................................................................................... 27
7.4.2 Inlet dust filter * ........................................................................................................28
7.4.3 Inlet desiccant trap * ................................................................................................... 28
7.4.4 Inlet chemical trap * ...................................................................................................28
7.4.5 Solenoid operated gas-ballast control valve ........................................................................28
7.4.6 Foreline trap * ...........................................................................................................28
7.4.7 Solenoid operated pipeline valve * ...................................................................................28
7.4.8 Outlet mist filter ........................................................................................................30
7.4.9 Oil drain extension .....................................................................................................30
7.4.10 Vibration isolators ......................................................................................................30
7.4.11 Pump inlet or outlet NW25 adaptor ..................................................................................30
Index .............................................................................................. 31
Illustrations
Figure Page
1 The E2M0.7, E2M1 and E2M1.5 pump ................................................................................. 3
2 Dimensions (mm) ........................................................................................................ 7
3 Inlet-filter removal and replacement ............................................................................... 21
4 Gas-ballast o-ring removal and replacement ....................................................................... 22
5 Accessories ...............................................................................................................29