© Edwards Limited 2008. All rights reserved. Page 41
Edwards and the Edwards logo are trademarks of Edwards Limited.
Spares and accessories
D396-14-880 Issue J
7 Spares and accessories
7.1 Introduction
Edwards products, spares and accessories are available worldwide from Edwards companies and our network of
distributors. Please refer to the back page of this manual or to www.edwardsvacuum.com for contact information.
Order spare parts and accessories from your nearest Edwards company or distributor. When you order, please state
for each part required:
z Model and Item Number of your equipment.
z Serial number (if any).
z Item Number and description of the part.
7.2 Spares
7.3 Accessories
7.3.1 Pump-to-controller cable
A pump-to-controller cable must be used with each pump. It is not supplied with the EXT pump or the EXC Controller.
The following cables are available:
7.3.2 BX bakeout band (EXC120/300/300M only)
A BX bakeout band accelerates the degassing of the pump to enable it to achieve lower pressures. It may also be used
to protect the pump from condensation of contaminants. The bakeout bands are available in 110-120 V or 220-240 V
versions and may be powered from a connector on the rear panel on the EXC120, EXC300 and EXC300M Controllers.
Spare Item Number
Electrical supply cable (2 m length, unterminated) D385-01-102
Logic interface connector
EXC120/120E Controllers D396-16-382
EXC300/300M Controllers D396-15-062
Backing pump relay connector
*
*
Not applicable to the EXC120E Controller.
D396-14-026
Cable Item Number
EXT70/250/351/501 EXT250M
Pump-to-controller cable, 1 m D396-18-010 D396-19-010
Pump-to-controller cable, 3 m D396-18-030 D396-19-030
Pump-to-controller cable, 5 m D396-18-050 D396-19-050
To Next Page
Loading...
