© Edwards Limited 2012. All rights reserved. Page 19
Edwards and the Edwards logo are trademarks of Edwards Limited.
Installation
A591-40-880 Issue A
6. Clip Screw Module (5) into Housing (6) so that terminal number 3 on Screw Module (5) is next to the Earth
terminal on Housing (6).
7. Connect the Earth wire of cable (1) to the Earth terminal on Housing (6).
8. Align Housing (6) with hood (3), ensure gasket (4) is in position.
9. Secure Housing (6) to hood (3) using the four screws supplied (7).
Figure 5 - Connect the electrical supply
1. 3-Phase mains cable.
2. Cable gland
3. Hood (M25)
4. Gasket
5. Screw Module (female)
6. Housing
7. Screws x 4
To Next Page
