© Edwards Limited 2010. All rights reserved. Page 31
Edwards and Edwards logo are trademarks of Edwards Limited.
Storage and disposal
A726-01-880 Issue M
6 Storage and disposal
6.1 Storage
Use the following procedure to store the pump:
1. Shut down the pump as described in Section 4.
2. Disconnect the pump from the electrical supply.
3. Purge your vacuum system and the pump with dry nitrogen and disconnect the pump from your vacuum system.
4. Place and secure protective covers over the inlet and outlet ports.
5. Store the pump in cool, dry conditions until required for use. When required, prepare and install the pump as
described in Section 3.
6.2 Disposal
Dispose of the pump and any components from it safely in accordance with all local and national safety and
environmental requirements.
Particular care must be taken with components which have been contaminated with dangerous process substances.
Do not incinerate fluoroelastomer seals and O-rings.
To Next Page
Loading...
Need help?
General
