Edwards XDS 10

Index
A726-01-880 Issue M
© Edwards Limited 2010. All rights reserved. Page 35
Edwards and Edwards logo are trademarks of Edwards Limited.
Numerics
62392
H6 Heading 4
5.4 Inspect and clean the gas-ballast
control (if fitted) 26
A
Accessories ............................................... 33
ATEX directive implications
..............................2
C
Construction ................................................4
CSA Product classification
...............................5
D
Description .................................................4
Dimensions .................................................9
Disposal
................................................... 31
E
Electrical data ........................................... 10
Electrical installation
single-phase pumps
................................14
three-phase pumps ................................17
F
Fault-finding ............................................. 28
G
Gas-ballast control ........................................4
Gas-ballast control (if fitted) .......................... 21
I
Inlet and outlet connections ........................... 18
Installation ............................................... 13
Introduction ................................................1
L
Leak test the system .................................... 19
Legislation and standards .............................. 11
Lifting the pump
......................................... 14
Locate the pump ........................................ 14
M
Maintenance .............................................. 25
Maintenance plan ........................................ 25
Mechanical data ......................................... 10
N
Noise and vibration data ............................... 10
O
Operating and storage conditions ......................7
Operation ................................................. 21
P
Performance ...............................................7
Performance characteristics
.............................8
R
Replace the tip seals and exhaust valve ............. 27
S
Safety ..................................................... 13
Scope and definitions .....................................1
Shut down ................................................ 23
Single-phase pumps
..................................... 10
Spares ..................................................... 33
Spares and accessories ................................. 33
Start up procedure
...................................... 21
Storage .................................................... 31
Storage and disposal .................................... 31
System design considerations
......................... 13
T
Technical data .............................................7
Test the motor condition
.............................. 27
The single-phase XDS dry pump .........................3
Three-phase pumps
..................................... 10
To achieve ultimate vacuum (if gas ballast fitted)
22
To pump condensable vapours ........................ 22
To pump condensable vapours (if gas ballast fitted)
.
22
U
Unpack and inspect ..................................... 13
Index