5
1) MOUNTING THE UNIT TO THE WALL
THIS HEATER MUST BE INSTALLED IN A LOCATION WHERE IT IS NOT SUBJECT TO
FREEZING TEMPERATURES.
The heater should be mounted under the sink as close to the point-of-use as possible. Ideal position is
fittings pointed down, but the heater can be mounted in any orientation.
Make sure to leave a minimum of 8 inches service
clearance at the end OPPOSITE the fittings.
Remove the cover and fasten to the wall using the
f
our mounting holes at each corner of the back plate.
Replace the cover.
Downloaded from https://gadgetsgo.com/Eemax-Accumix-II-277V-tankless-commercial-sinks.html Authorized Eemax Distributor
To Next Page
Loading...
