FAQS
2019
Step 6 - Time Period Button
Press time period button to change from daily, to weekly and to monthly data during AVERAGE
or HISTORY mode. During HISTORY mode the backward and forward buttons are used to
scroll between date, weeks and months.
If I remove the batteries will I lose the information on the display?
The display has an internal memory, so if you need to change or remove the batteries
the information stored on the display will not be lost.
How do I reset the display (clear the data and start again)?
Press time period and unit set buttons simultaneously and hold for two seconds CLR
will be displayed on the screen.
How far does the device transmit?
Transmitters work up to around 230ft/40m within the home. The 433.5MHz range is
well suited for home use. This can cover three floors, and also well suited to buildings
where electricity meters are outside the main building.
I have dashes (- - - -) showing on the display. What does this mean?
Move the display closer to the transmitter and press the link button. If the dashes remain
on the display this would indicate the transmitter and receiver are not communicating.
Please contact efergy Customer Service to help locate the problem.
Backlight appears to work sometimes, and not other times. Is my display broken?
No. The backlight is on a timer to save battery life. The display should work at darker
periods of the day, when any buttons are pressed. The LED backlight will be activated
from 18:00Hrs to 6:00Hrs.
For more information about the e2 and the elink software go to www.efergy.us
HOW TO CHANGE MODES CONTINUED
MONITOR SETUP
Day Week Month
Day Week Month
Shop for Power Metering products online at:
1.877.766.5412
www.PowerMeterStore.ca
To Next Page
Loading...
Need help?
Transmission
