3.2.4 Mains input
IEC inlet connector 10 A.
IEC inlet connector 16 A with types 2000RM / 3000RM IEC.
Mains connection via appended connection cable with safety plug.
The protective conductor must be connected!
Please always regard the indicated input voltage on the identification
label or in the technical data of this manual.
3.2.5 Input and output over-voltage protection
Over-voltage protection for phone, fax or modem.
3.2.6 Circuit breaker for mains input
In the event of high over-currents or a device defect (e.g. internal short circuit),
the circuit breaker switches it off, and the device is thus immediately separated
from the connected mains.
3.2.7 Circuit breaker for mains output
In the event of high over-currents or a device defect (e.g. short-circuit of the
loads), the circuit breaker switches it off. The load is thus separated from the
UPS.
To Next Page
Loading...
