Installation Guide
Fiery proServer, version 7.1
This document describes how to install the Fiery proServer. The Fiery proServer is always installed by a qualified EFI
technician or dealer.
This document covers the following topics:
•
Checking the site conditions
•
Installing the furniture
•
Connecting the Fiery proServer to the network and to the printer
•
Starting and stopping the Fiery proServer
•
Fiery QuickTouch
•
Changing the language of the Fiery proServer
•
Activating the Fiery XF server license
•
Installing Command WorkStation on a remote computer
•
Setting up a network bridge
•
Available documentation
Note: The term Fiery proServer refers to Fiery proServer Premium and Fiery proServer SE hardware. Different
procedures are provided for each when necessary.
Checking the site conditions
Before you install the Fiery proServer, check the site conditions, and make sure the network is available.
Printer readiness
•
Is adequate space available near the printer for the Fiery proServer?
•
Does the printer require service or adjustments?
Before you install the Fiery proServer, print the printer color test page. If the quality of the test page indicates
that the printer needs adjustment, complete the necessary service to the printer.
•
Is there sufficient space for the Fiery proServer and optional furniture (if present)?
Make sure there is sufficient space for the cables at the back and sides of the Fiery proServer.
© 2019 Electronics For Imaging, Inc.
15 February 2019
45193361
*45193361*
To Next Page
Need help?
General
