20cm+ (8 in.)
20cm+ (8 in.)
1 Back panel
2 Fiery proServer
3 Side panel
Network
•
Make sure that the network is available. For more information on the required network ports, see Network ports
on page 2.
•
Verify with the IT administrator that the network is functioning.
•
Ensure that the IT administrator is available during the installation.
Equipment downtime and impact on the network can be minimized if the IT administrator installs a network
connector for the Fiery proServer and confirms network functionality with the connector in place before the Fiery
proServer installation.
When the site is ready, installation of the Fiery proServer takes about three hours.
Network ports
When checking the availability of the network or installing anti-virus software, make sure that the following network
ports are not blocked as they are needed for specific features of Command WorkStation.
Port
Used for
4108 Epson Spectroproofer
8010, 8013 Bi-directional communication service
8020, 8022, 8030, 8032 Integration and connectivity between Fiery XF server and EFI printers
8051, 8052, 8053, 8054, 8061, 8062, 8063,
8064
Communication between Fiery XF server and APPE processes (up to four
instances)
26502, 27000 to 27009, 60000 License management/EFI Cut Server
50005 to 50026 General communication between the Fiery XF server and Command
WorkStation
Installation Guide
Fiery proServer, version 7.1
2
To Next Page
Loading...
Need help?
General
