EFOY GO! - Page 38

Faults and remedies
Page 38
English
No.
LED
display
Problem Description Solution
3 Battery
temperature
The temperature of
the EFOY GO! is too
high / too low.
Wait until the EFOY
GO! has cooled down
/ warmed up. Then
switch the EFOY GO!
back on.
4 12 V
connection
overload /
short circuit
The load on the 12 V
connection is too high
or a short circuit has
occurred.
Disconnect the load
from the 12 V
connection and
switch the EFOY GO!
back on. Please
check the current
consumption of your
load (I < 10 A).
5 230 V
connection
overload /
short circuit
The load on the 230 V
connection is too high
or a short circuit has
occurred.
Disconnect the load
from the 230 V
connection and
switch the EFOY GO!
back on. Please
check the power
consumption of your
load (P < 400 W).
9 Internal
error*
An internal error has
occurred.
Switch the EFOY GO!
back on. If the error
occurs again, please
contact the EFOY
Hotline. You will find
contact details in
chapter 1.2 “
Service
contact” on page 21.
*To read off the internal error code, start-up the EFOY GO! and press the (grey)
Power ON / OFF button on the right for more than ten seconds and count how often
the LEDs light up. This number indicates the internal error code. Pass the internal
error code on to the SFC service engineer.
Copyright 2015 – version 00 – 155 901 001