3
Warning
1. All work on this product must be carried out by qualified personnel. To
reduce the risk of electric shock, do not perform any servicing other than that
specified in the operating instructions unless you are qualified to do so.
2. Read all instructions before commencing installation. For electrical work, follow all local
and national wiring standards, regulations, and these installation instructions. All wiring
should be in accordance with the National Electrical Code (NEC), ANSI/NFPA 70.
3. The battery and system can connect with the utility grid only if the utility provider
permits. Consult with your local AHJ before installing this product for any additional
regulations and requirements for your area.
4. All warning labels and nameplates on this battery should be clearly visible and must
not be removed or covered.
5. The installer should consider the safety of future users when choosing the battery’s
correct position and location as specified in this manual.
6. Please keep children away from touching or misusing the battery and relevant systems.
7. Battery is designed to stop charging at 32°F. If charging current is observed when the internal
battery temperature is below 32°F, disconnect battery immediately and consult manufacturer.
DISCLAIMER
EG4® reserves the right to make changes to the material herein at any time without notice. You
may refer to the EG4® website at www.eg4electronics.com for the most updated version of our
manual.
To Next Page
Loading...
Need help?
General
