→ “Yes / Call / Dial” Dials the number stored under that name
→ “No / Back” The number for the recognized name is not dialed
→ “Abort / Cancel“ Ends the dialogue without carrying out a function
→ “Help” Calls up Help and an explanation of possible commands
“Call / Dial <name> at home … on the cell phone”
With this command, you may dial a specific type of number from a contacts list entry. If the name is recognized, you will be asked if
the name should really be dialed. The following commands are available to you:
→ “Yes / Call / Dial” Dials the number stored under that name
→ “No / Back” The number for the recognized name is not dialed
→ “Abort / Cancel“ Ends the dialogue without carrying out a function
→ “Help” Calls up Help and an explanation of possible commands
“Dial number”
You will be prompted to enter the number to be dialed. This may be done with individual numerals as well as groups of numbers.
If you insert a pause, the last number/group of numbers entered is repeated for checking. In addition, you will be notified if you
exceed the maximum telephone number length. In addition to continuing with the entry of numerals, the following additional com-
mands are available:
→ „+, *, #, 0, 1, …, 9“ For entering the number
→ “Delete all” To delete the entire phone number entered
→ “Delete / Correct / Change” To delete the last number/group of numbers entered
→ “Repeat” To announce the entire phone number entered up to this point
→ “Yes / Call / Dial” To dial the phone number entered
→ “No / Back” To not dial the number entered
→ “Abort / Cancel“ Ends the dialogue without carrying out a function
→ “Help” Calls up Help and an explanation of possible commands
EGO FLASH
To Next Page
Loading...