EasyManuals Logo

Ei Electronics Ei168RC Installation Manual

Ei Electronics Ei168RC
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
13
A maximum of 12 RadioLink bases may be used in any one system. If your system has
more than 12 Alarms please consult your supplier or contact tech support (see back page).
House Coding
When all the RadioLINK bases have been installed and fitted with Alarms, you are now
ready to house code the system.
It is essential to House Code the RadioLINK bases to ensure they will not
accidently communicate with nearby systems. Failure to house code the
system may also result in a system malfunction.
Press and hold the House Code switch on the
side of any one of the RadioLINK Bases with a
small screwdriver until the blue light illuminates.
Immediately release the switch and the blue light
will flash quickly and then stop. The flashing will
repeat every 5 to 10 seconds thereafter.
Repeat this procedure for all Alarms in the system.
Any additional RF devices being used in the system,
e.g. Ei450 remote controller must also be included in
the house coding. For house coding instructions of
RF devices consult their manuals.
WARNING
BLUE LIGHT
HOUSE CODE SWITCH
13

Other manuals for Ei Electronics Ei168RC

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ei Electronics Ei168RC and is the answer not in the manual?

Ei Electronics Ei168RC Specifications

General IconGeneral
BrandEi Electronics
ModelEi168RC
CategorySmoke Alarm
LanguageEnglish

Related product manuals