15
Note: Some RF devices do not support the on
demand exit house code feature. You may allow
them to automatically exit house code after the
time period or if you wish, you can do it manually.
Consult the individual RF device manual for
further instructions.
Check the communication by pressing the test/
hush button for up to 20 seconds on each unit in
turn. The red light will flash, the Alarm will sound
and blue light on the RadioLINK Base sidewall will
illuminate continuously for around 3.5 seconds.
All other Alarms should sound (this may take up
to 20 seconds).
Before testing the next alarm allow a minimum
of one minute after the last alarm has stopped
sounding from the previous test.
If all the units are not communicating consult
the “Troubleshooting the RF link” section for
information on how to resolve the problem.
BLUE LIGHT
HOUSE CODE SWITCH
To Next Page
Loading...
Need help?
General
