EasyManuals Logo

EINHELL TC-SM 2531/2 U User Manual

EINHELL TC-SM 2531/2 U
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #48 background imageLoading...
Page #48 background image
GBGB
- 48 -
11. Service information
We have competent service partners in all coun-
tries named on the guarantee certicate whose
contact details can also be found on the guaran-
tee certicate. These partners will help you with
all service requests such as repairs, spare and
wearing part orders or the purchase of
consumables.
Please note that the following parts of this product
are subject to normal or natural wear and that the
following parts are therefore also required for use
as consumables.
Drag, cross cut
and miter saw Parts
Wear parts* Carbon brushes
Consumables* Cutting disc
* Not necessarily included in the scope of
delivery!
In the eect of defects or faults, please inform the
problem to the contact address indicated at the
warranty card of your country. Please
ensure that you provide a precise description of
the problem and answer the following questions
in all cases:
Did the equipment work at all or was it defec-
tive from the beginning?
Did you notice anything (symptom or defect)
prior to the failure?
What malfunction does the equipment have in
your opinion (main symptom)?
Describe this malfunction.
Never place any electric power tools in your household refuse.
Old electric and electronic equipment and old electric power tools have to be separated from other was-
te and disposed of in an environment-friendly fashion, e.g. by taking to a recycling depot, according to
the local legal requirements.
The reprinting or reproduction by any other means, in whole or in part, of documentation and papers ac-
companying products is permitted only with the express consent of the www.einhell-service.com.
Subject to technical changes without prior notice.
The product meets the requirements of EN 61000-3-11 and is subject to special connection condi-
tions. This means that use of the product at any freely selectable connection point is not allowed.
Given unfavorable conditions in the power supply the product can cause the voltage to fluctuate
temporarily.
The product is intended solely for use at connection points that
a) do not exceed a maximum permitted mains system impedance of Z sys = 0,25 + j 0,25 Ω, or
b) have a continuous current-carrying capacity of the mains of at least 100 A per phase.
As the user, you are required to ensure, in consultation with your electric power company if neces-
sary, that the connection point at which you wish to operate the product meets one of the two requi-
rements, a) or b), named above.
Anl_TC_SM_2531_2_U_SPK8.indb 48Anl_TC_SM_2531_2_U_SPK8.indb 48 30.06.2021 08:18:5930.06.2021 08:18:59

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the EINHELL TC-SM 2531/2 U and is the answer not in the manual?

EINHELL TC-SM 2531/2 U Specifications

General IconGeneral
BrandEINHELL
ModelTC-SM 2531/2 U
CategorySaw
LanguageEnglish

Related product manuals