GB
Anl_TC_TS_200_SPK9.indb 28 13.11.2019 12:55:57
(See 7.2.)
• S witch on the saw.
• P lace your hands (with fingers closed) flat
on the workpiece and push the workpiece
along the parallel stop (7) and into the blade
(4).
• G uide at the side with your left or right hand
(depending on the position of the parallel
stop) only as far as the front edge of the
guard hood.
• A lways push the workpiece through to the
end of the splitter (5).
• T he offcut piece remains on the saw table
(1) until the blade (4) is back in its position of
rest.
• S ecure long workpieces against falling off at
the end of the cut (e.g. with a roller stand
etc.)
8.1.1 Cutting narrow workpieces (Fig. 15) Be
sure to use a push stick (3) when making
longitudinal cuts in workpieces smaller than 150
mm in width. A push stick is supplied with the saw!
Replace a worn or damaged push stick
immediately.
- 24 -
To Next Page
Loading...
