EINHELL TC-TS 2225 U User Manual

GB
- 58 -
splitter.
2) Safety information for sawing
a) DANGER: Do not let your hands and fi ngers come anywhe-
re near the saw blade or the sawing area. It just takes one
moment of inattention or a slip and your hand could be directed
towards the saw blade, which could result in serious injuries.
b) Only feed the workpiece to the saw blade or cutting tool
against the direction of rotation. If the workpiece is fed in in
the same direction as the direction of rotation of the saw blade
above the table, this could lead to both the workpiece and your
hand being drawn in to the saw blade.
c) Never use the miter stop to feed in the workpiece when
performing longitudinal cuts, and never use the parallel
stop in addition for setting the length when performing
cross cuts with the miter stop. Feeding the workpiece in with
both the parallel stop and the miter stop at the same time incre-
ases the likelihood of the saw blade getting jammed, which will
result in kickback.
d) When performing longitudinal cuts, always apply the infeed
force on the workpiece between the stop rail and the saw
blade. Use a push stick if the gap between the stop rail and
the saw blade is less than 150 mm, and a push block if the
gap is less than 50 mm. Work aids of this kind help ensure that
your hand is kept at a safe distance from the saw blade.
e) Only use the supplied push stick of the manufacturer or
one which has been manufactured in accordance with in-
structions. The push stick ensures that your hand is kept at a
suffi cient distance from the saw blade.
f) Never use a damaged or partially sawn push stick. If the
push stick is damaged, it could break, causing your hand to
come into contact with the saw blade.
g) Do not perform your work “free-handed”. Always use the
parallel stop or the miter stop to position and feed in the
workpiece. “Free-handed” means using your hand to support or
Anl_TC_TS_2225_U_SPK7_Rewe.indb 58 24.03.2020 10:29:24

EINHELL TC-TS 2225 U Specifications

General

Product color	Red, Silver
Quick stop function	Yes
Idle speed	4250 RPM
Cutting height @ 45°	55 mm
Cutting height @ 90°	80 mm
Cross stop tilt angle range	-45 - 45 °
Input power	1800 W
AC input voltage	220 - 240 V
AC input frequency	50 Hz
Saw blade type	Single
Number of teeth	48
Number of saw blades	1
Package depth	615 mm
Package width	715 mm
Package weight	28600 g

Weight and Dimensions

Depth	750 mm
Width	610 mm
Height	380 mm
Weight	17460 g
Table depth	555 mm
Table width	580 mm
Bore diameter	30 mm
Blade diameter	254 mm
Height adjustment range	0 - 80 mm