EINHELL TC-TS 2225 U User Manual

GB
- 81 -
and cannot become jammed.
•
The table length extension (35) can be extended at the back and
is limited by screws (52) (see 4. Technical data)
•
To lock the table length extension (35) in a specific position, you
can secure it with the locking screws (32).
8. Operation
Warning!
•
After every new adjustment we recommend you to make a trial
cut in order to check the new settings.
•
After switching on the saw, wait for the blade to reach its maxi-
mum speed of rotation before commencing with the cut.
•
Take extra care when starting the cut!
•
Never use the equipment without the suction function.
•
Regularly check and clean the suction channels.
8.1 Making longitudinal cuts (Figure 21)
Longitudinal cutting (also known as slitting) is when you use the
saw to cut along the grain of the wood. Press one edge of the work-
piece against the parallel stop (7) while the fl at side lies on the
saw table (1). The guard hood (2) must always be lowered over the
workpiece.
When you make a longitudinal cut, never adopt a working position
that is in line with the cutting direction.
•
Set the parallel stop (7) in accordance with the workpiece height
and the desired width. (See 7.3.)
•
Switch on the saw.
•
Place your hands (with fingers closed) flat on the workpiece and
push the workpiece along the parallel stop (7) and into the blade
(4).
•
Guide at the side with your left or right hand (depending on the
position of the parallel stop) only as far as the front edge of the
guard hood.
•
Always push the workpiece through to the end of the splitter (5).
Anl_TC_TS_2225_U_SPK7_Rewe.indb 81 24.03.2020 10:29:26

EINHELL TC-TS 2225 U Specifications

General

Product color	Red, Silver
Quick stop function	Yes
Idle speed	4250 RPM
Cutting height @ 45°	55 mm
Cutting height @ 90°	80 mm
Cross stop tilt angle range	-45 - 45 °
Input power	1800 W
AC input voltage	220 - 240 V
AC input frequency	50 Hz
Saw blade type	Single
Number of teeth	48
Number of saw blades	1
Package depth	615 mm
Package width	715 mm
Package weight	28600 g

Weight and Dimensions

Depth	750 mm
Width	610 mm
Height	380 mm
Weight	17460 g
Table depth	555 mm
Table width	580 mm
Bore diameter	30 mm
Blade diameter	254 mm
Height adjustment range	0 - 80 mm