EINHELL TC-TS 2225 U User Manual

GB
- 83 -
the cross stop from making contact with the blade guard.
•
Press the workpiece firmly against the cross stop (14).
•
Switch on the saw.
•
Push the cross stop (14) and the workpiece toward the blade in
order to make the cut.
•
Warning!
Always hold the guided part of the workpiece. Never hold the
part which is to be cut off.
•
Push the cross stop (14) forward until the workpiece is cut all the
way through.
•
Switch off the saw again. Do not remove the offcut until the blade
has stopped rotating.
9. Replacing the power cable
Danger!
If the power cable for this equipment is damaged, it must be repla-
ced by the manufacturer or its after-sales service or similarly trai-
ned personnel to avoid danger.
10. Cleaning, maintenance and ordering of spare parts
Danger!
Always pull out the mains power plug before starting any cleaning
work.
10.1 Cleaning
•
Keep all safety devices, air vents and the motor housing free of
dirt and dust as far as possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low pressure.
•
We recommend that you clean the device immediately each time
you have finished using it.
•
Clean the equipment regularly with a moist cloth and some soft
Anl_TC_TS_2225_U_SPK7_Rewe.indb 83 24.03.2020 10:29:27

EINHELL TC-TS 2225 U Specifications

General

Product color	Red, Silver
Quick stop function	Yes
Idle speed	4250 RPM
Cutting height @ 45°	55 mm
Cutting height @ 90°	80 mm
Cross stop tilt angle range	-45 - 45 °
Input power	1800 W
AC input voltage	220 - 240 V
AC input frequency	50 Hz
Saw blade type	Single
Number of teeth	48
Number of saw blades	1
Package depth	615 mm
Package width	715 mm
Package weight	28600 g

Weight and Dimensions

Depth	750 mm
Width	610 mm
Height	380 mm
Weight	17460 g
Table depth	555 mm
Table width	580 mm
Bore diameter	30 mm
Blade diameter	254 mm
Height adjustment range	0 - 80 mm