GB
- 19 -
3. Proper use
The wet grinder is designed for sharpening and
honing the blades of chisels or similar tools.
The machine is allowed to be used only for its
intended purpose! Even when the equipment is
used as prescribed it is still impossible to elimina-
te certain residual risk factors. The following ha-
zards may arise in connection with the machine‘s
construction and layout:
•
Contact with the grinding wheel where it is not
covered.
•
Catapulting of parts from out of damaged
grinding wheels.
•
Catapulting of workpieces and parts of work-
pieces.
•
Damage to hearing if essential ear-muffs are
not used.
The equipment is allowed to be used only for its
prescribed purpose. Any other use is deemed to
be a case of misuse. The user/operator and not
the manufacturer will be liable for any damage or
injuries of any kind resulting from such misuse.
Please note that our equipment has not been de-
signed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
equipment is used in commercial, trade or indust-
rial businesses or for equivalent purposes.
4. Technical data
Mains voltage: ........................220-240 V ~ 50 Hz
Power rating: ............................................ 125 W
Idle speed n
0
: ........................................110 min
-1
Mounting Ø of support arm: ..................... 12 mm
Protection class ................................................. I
Protection type: ........................................... IPX0
Weight: ............................................ approx. 8 kg
Wet grinding wheel:
Grinding wheel Ø max. ........................... 207 mm
Grinding wheel Ø min.: ........................... 153 mm
Grinding wheel Ø: .................................. 200 mm
Grinding wheel thickness: ........................ 40 mm
Grinding wheel hole Ø: ............................. 32 mm
Circumferential speed: ...........................1.15 m/s
Grinding wheel grit size: ..............................K220
Honing wheel:
Wheel Ø: ................................................ 180 mm
Wheel thickness: ...................................... 30 mm
Circumferential speed: ...........................1.04 m/s
Danger!
Noise
The noise emission values were measured in ac-
cordance with EN 62841.
Operation
L
pA
sound pressure level ........................ 79 dB(A)
K
pA
uncertainty ........................................ 3 dB(A)
L
WA
sound power level .......................... 92 dB(A)
K
WA
uncertainty ........................................ 3 dB(A)
Wear ear-muff s.
The impact of noise can cause damage to hea-
ring.
The stated noise emission values were measured
in accordance with a set of standardized criteria
and can be used to compare one power tool with
another.
The stated noise emission values can also be
used to make an initial assessment of exposure.
Warning:
The noise emission levels may vary from the level
specifi ed during actual use, depending on the
way in which the power tool is used, especially
the type of workpiece it is used for.
Keep the noise emissions and vibrations to a
minimum.
•
Only use appliances which are in perfect wor-
king order.
•
Service and clean the appliance regularly.
•
Adapt your working style to suit the appliance.
•
Do not overload the appliance.
•
Have the appliance serviced whenever ne-
cessary.
•
Switch the appliance off when it is not in use.
Limit the operating time!
All stages of the operating cycle must be conside-
red (for example, times in which the electric tools
are switched off and times in which the tool is
switched on but operates without load).
Anl_TC-WG_200_SPK9.indb 19 07.09.2020 14:38:51
To Next Page
Loading...
