Eizo FlexScan EV2316W

39
Chapter4PowerSavingFunctions
5. When “On” is selected, select “EcoView Sense Settings” for setting the details.
Item Setting Range Description
Time 5,30sec
1,3,5,10,15,30,45,
60min
Speciesthetimefromwhenapersonleavesthemonitoruntilthe
“NoPresencedetected”messageappears.Themonitorshiftsto
thepowersavingmodeabout20secondsafterthemessageis
displayed.
Sensitivity Level5
Level4
Level3
Level2
Level1
Whenthesettinglevelishigh(“Level5”atmaximum),evenminor
movementsofapersonaredetected,causingthemonitortoshift
tothepowersavingmodeonlyinfrequently.Ontheotherhand,
whenthesettinglevelislow(“Level1”atminimum),onlymajor
movementsofapersonaredetected,allowingthemonitortoshift
tothepowersavingmodefrequently.EcoViewSenseisactivated
whenthesensoronthefrontsideofthemonitordetectsthe
movementofheat.Therefore,thesensitivityshouldbechanged
dependingonthetypicaluser’sclothesorthetypicalroom
temperature.Ifthemonitorshiftstoorrecoversfromthepower
savingmodecontrarytoyourexpectations,trychangingthesetting
level.
Reset - Thisfunctionresetsalladjustmentstothedefaultsettings.
Note
• When the monitor is used in the “Portrait” direction, the detection sensitivity is lower than the “Landscape” direction.
Try increasing the sensitivity setting value when switching the mode to the power saving mode.
• To use the monitor comfortably, increase the sensitivity for high temperatures, which reduces the detection sensitivity,
and reduce the sensitivity for low temperatures, which increases the detection sensitivity.