5-3. Imaging Problems (For Analog Only)
Problem Possible cause and remedy
1. Display position is incorrect. • Use “Position” in the Setting menu to correct the image
position (see “Hor. Position”, “Ver. Position” (page 22)).
• If the problem persists, use the graphics board’s utility if
available to change the display position.
2. Vertical bars appear on the screen or a part
of the image is ickering.
• Use “Clock” in the Setting menu to adjust it (see “Clock”
(page 22)).
3. Whole screen is ickering or blurring.
• Use “Phase” in the Setting menu to adjust it (see “Phase”
(page 22)).
30
Chapter 5 Troubleshooting
To Next Page