37
Chapter 6 Reference
6-2. Detaching/Attaching Stand Base
Detaching procedure
The stand base that was attached during setup can be detached using the following procedures.
1.
Lay the LCD monitor on a soft cloth spread over on a stable surface with the
panel surface facing down.
2.
Turnthexingscrewonthestandbasetodetachit.
Note
• The xing screw can be removed by hand. If the xing screw is too tight, use a coin or athead screwdriver.
3.
Turn the stand base in the counterclockwise direction to detach it.
Note
• Reattach the xing screw onto the stand base for when the stand base is used again.
To Next Page
Loading...
Need help?
General
