26
Chapter 4 Power Saving Functions
5. When “On” is selected, select “EcoView Sense Settings” for setting the details.
Item Setting Range Description
Time 5, 30 sec
1, 3, 5, 10, 15, 30, 45,
60 min
Species the time from when a person leaves the monitor until the
“No Presence detected” message appears. The monitor shifts to
the power saving mode about 20 seconds after the message is
displayed.
Sensitivity Level 5
Level 4
Level 3
Level 2
Level 1
When the setting level is high (“Level 5” at maximum), even minor
movements of a person are detected, causing the monitor to shift
to the power saving mode only infrequently. On the other hand,
when the setting level is low (“Level 1” at minimum), only major
movements of a person are detected, allowing the monitor to shift
to the power saving mode frequently. EcoView Sense is activated
when the sensor on the front side of the monitor detects the
movement of heat. Therefore, the sensitivity should be changed
depending on the typical user’s clothes or the typical room
temperature. If the monitor shifts to or recovers from the power
saving mode contrary to your expectations, try changing the setting
level.
Reset - This function resets all adjustments to the default settings.
Note
• To use the monitor comfortably, increase the sensitivity for high temperatures, which reduces the detection
sensitivity, and reduce the sensitivity for low temperatures, which increases the detection sensitivity.
To Next Page
Loading...
Need help?
General