18
4 POWER-SAVE SETUP
NUTEK System
1) First make the appropriate ScreenSaver settings (Macintosh/Energy
Saver) for the PC.
2) Then select ‘NUTEK’.
3) Set the delay time, which is the interval between the time that the
ScreenSaver (Macintosh/EnergySaver) blanks the screen and the time
that the monitor enters Mode 1.
4) Set the Mode 1 duration time which is the user definable time (0-60
minutes) before the monitor enters Mode 2.
NUTEK power-saving method
Mode 1 operates for a user-definable period in ‘Duration’ (in 0-60
minutes) before the monitor enters Mode 2. If the keyboard or the
mouse are not in use during this period, the monitor will then enter
PowerManager Mode 2.
To Next Page
Loading...
