ekwb EK-AIO 120 D-RGB - SAFETY PRECAUTIONS; SPECIFICATIONS

- 4 -
This product is intended for installation by expert users only. Please, consult with a qualifi ed
technician. Improper installation may result in damage to your equipment. EK Water Blocks
assumes no liability whatsoever, expressed or implied, for the use of these products or their
installation. The following instructions are subject to change without notice. Please visit our web
site at www.ekwb.com for updates.
1. SAFETY PRECAUTIONS
1. Keep and store the product away from the reach of children.
2. Check the component list and condition of the product before installation. If you encounter
a problem, contact the shop where you have purchased the product to get a replacement or
a refund.
3. EKWB d.o.o. is not responsible for any damages due to external causes, including but not
limited to: improper use, problems with electrical power, accident, neglect, alteration, repair,
improper installation, and improper testing.
4. CPU and motherboard are subject to damage if the product is incorrectly installed.
5. The excessive force exerted on the fan may cause damage to the fan and/or system.
6. This product is a CPU liquid cooling solution kit, comprising of individual original EKWB parts.
Combining this liquid cooling unit with parts, other than EK Water Block products, may lead to
warranty loss.
7. Product design and specifi cations may be revised to improve quality and performance.
2. SPECIFICATIONS
Model EK-AIO 120 D-RGB EK-AIO 240 D-RGB EK-AIO 360 D-RGB
Radiator
Dimensions
155x120x27 mm 275x120x27 mm 395x120x27 mm
Fin material Al, Cu Al, Cu Al, Cu
Fan
Dimensions 120x120x25 mm 120x120x25 mm (2x) 120x120x25 mm (3x)
Speed
600-2200
RPM ±10%
(PWM: 25-100%)
600-2200
RPM ±10%
(PWM: 25-100%)
600-2200
RPM ±10%
(PWM: 25-100%)
Air Flow 77 CFM 77 CFM 77 CFM
Life Expectancy 50,000 hours 50,000 hours 50,000 hours
Noise Level 33.5 dB 33.5 dB 33.5 dB
Bearing Type
Fluid Dynamic bearing
(FDB)
Fluid Dynamic bearing
(FDB)
Fluid Dynamic bearing
(FDB)
Connector 4-Pin 4-Pin 4-Pin
Rated Voltage 12V 12V 12V
Pump
Dimensions (mm) 88x70x53 mm 88x70x53 mm 88x70x53 mm
RPM
450-2600 RPM ± 10%
(PWM: 20-100%)
450-2600 RPM ±10%
(PWM: 20-100%)
450-2600 RPM ±10%
(PWM: 20-100%)
Life Expectancy 50,000 hours 50,000 hours 50,000 hours
Noise Level 23 dB 23 dB 23 dB
Input Current 0.65 ±10% A 0.65 ±10% A 0.65 ±10% A