ekwb EK-MSI Z690 Carbon EK X - Placing the Block on to Motherboard; Step 1: Install Standoff Washers; Step 2: Position Monoblock

- 7 -
STEP 1
Install four (4) M2.5 self adhesive PVC washers under marked
standoffs as shown on the picture below.
STEP 2
Place the EK-MSI Z690 Carbon EK X Monoblock series water block to
the motherboard or vice versa (as shown on the photo). Make sure
that mounting holes are aligned.
PLACING THE BLOCK ON TO MOTHERBOARD
M2.5 SELF ADHESIVE
PVC WASHER
STEP 1
STEP 2