6
The pressurisation unit is delivered
as a single carton containing:
• Assembled and factory tested
pressurisation unit.
• Wall mounting bracket.
(Supplied attached to the
front of the water tank.)
5.0 Location
The pressurisation unit is not suitable
for installation external to a building.
The position chosen for the appliance
shall be a structurally sound wall
capable of supporting the filled
weight of the appliance and all
associated ancillary equipment.
The wall shall be plumb vertical
to ensure correct operation.
6.0 Installation
For ease of installation, commissioning,
servicing and maintenance the following
clearances should be observed.
NOTE: These distances are
MINIMUM and MUST NOT be
reduced. Failure to observe
these clearances could result in
the warranties on the appliance
becoming VOID.
7.0 Wall Mounting
A mounting bracket is supplied inside
the unit taped to the front of the tank.
It is intended that this bracket should
be fixed to the wall and the unit hung
from it.
Each wall mounted unit also has two
holes in the back of the chassis for
extra security.
The corresponding holes in the wall
should be drilled to suit once the unit
is mounted on its bracket. The bracket
dimensions are shown in Fig 7 below.
Note: The wall shall be plumb vertical
to ensure correct operation.
4.0 Delivery and Packaging
Delivery and Packaging
PLAN VIEW
100
150
450
Figure 6 0 – Clearances
382
600
151 80
6.6dia
125
Figure 7 0 – Wall mounting
To Next Page
Loading...