Elcometer 355 User Manual

R
34
E11 No readings were taken before trying to enter a base or cal factor.
E12 Limits cannot be changed in a batch with readings.
E13 Batch number entered cannot be found or Selected batch type not available.
E14 The probe module currently used is different to when this batch was created.
E15 The probe module is not responding or is not plugged in.
E16 Maximum number of batches exceeded.
E17 The limit set exceeds the range of the probe module in use.
E18 Calibration Factor error. Too large a value has been entered for a Cal Factor.
E99 Cannot complete standard deviation calculation
Code Explanation

Elcometer 355 Specifications

General

Brand	Elcometer
Model	355
Category	Measuring Instruments
Language	English