R
5
2 GETTING STARTED
2.1 REMOVING THE CASE
To remove the leather case to gain access to the module and
battery compartments, undo the retaining screw located on the
bottom of the case and remove the gauge by pushing it through
the hole.
2.2 FITTING BATTERIES
Batteries are located under the cover at the rear of the gauge.
Fit three LR6 (AA), alkaline dry batteries, or rechargeable
equivalent; take care to ensure correct battery polarity.
When the battery symbol is shown on the display, the
batteries should be replaced. When the symbol starts flashing,
the batteries will last approximately one more hour.
Note: Remove the batteries from the instrument if it is to remain
unused for a long period of time. This will prevent damage to the
instrument in the event of malfunction of the batteries.
Note: All batteries must be disposed of carefully to avoid
environmental contamination. Please consult your local
Environmental Authority for information on disposal in your
region.
Do not dispose of any batteries in fire.
(Elcometer 355
Top model shown)
To Next Page
Loading...
Need help?
General
