Elcometer 355 - Page 54

R
52
Calibration
In the following section [n] or [n.n] is a number.
[BASE] Select mode [CAL]
[0], [n.n] Enter value [n.n]
or or
[BASE] Select previous value [CAL]
[ENTER] [ENTER]
Setting Limits
[LIMIT] Select mode
[<] or [>] High or low limit
[n.n] [ENTER] Enter value (high or low)
[n.n] [ENTER] Enter value (high or low)
Batch Mode
[BATCH] Select mode
[BATCH] Scroll through batches
or [n...] or enter number
[ENTER] Select batch